AMETEK M130 - Manual (Page 9)

M130/131 Programming Manual iii
CONTENTS
SECTION 1
FEATURES, FUNCTIONS, AND SPECIFICATIONS ..... 1-1
1.1 Introduction .................................................................................................... 1-1
1.2 Features and Functions .................................................................................. 1-2
1.2.1 Features ............................................................................................. 1-2
1.2.2 Programmable Functions ................................................................... 1-3
1.2.3 Readback Functions ........................................................................... 1-3
1.3 Specifications ................................................................................................. 1-3
1.3.1 Ethernet/LAN Configuration ................................................................ 1-3
1.3.2 Ethernet Configuration Factory Defaults ............................................. 1-4
1.3.3 Programming Resolution .................................................................... 1-4
1.3.4 Programming Accuracy ...................................................................... 1-4
1.3.5 Readback Resolution ......................................................................... 1-5
1.3.6 Readback Accuracy ............................................................................ 1-5
SECTION 2
CONFIGURATION ....................................................... 2-1
2.1 Setup Procedure ............................................................................................ 2-1
2.1.1 M130 Network Setup Using DHCP ..................................................... 2-1
2.1.2 M130 Network Setup Using Auto-IP ................................................... 2-2
2.1.3 M130 Network Setup Using the Serial COM Port ............................... 2-3
2.1.4 M130 Network Setup Using Web Browser .......................................... 2-4
2.2 Rear Panel ..................................................................................................... 2-5
2.2.1 M130 (Master) Option ........................................................................ 2-5
2.2.2 M131 (Slave) Option ........................................................................... 2-6
2.2.3 Configuration Switch ........................................................................... 2-8
2.2.4 Remote/Local Selection ...................................................................... 2-9
2.3 External User Control Signal Connector ....................................................... 2-10
2.4 Programming Via Ethernet ........................................................................... 2-12