AMETEK M130 - Manual (Page 31)

Sorensen Ethernet Option Configuration
M130/M131 Programming Manual 2-13
Ethernet Web Pages, Overview
The layout of each of the Web pages includes the banner with the heading,
“Sorensen DLM (or DCS) Power Supply Interface” along with the device name
below and a LOGIN button to the right. Below the banner are six tabs, each linked
to its corresponding page. On each page is a title line (title matches tab name). In
the title line is an area that frequently displays informational messages as you use
the Web interface.
When navigating to the Ethernet Web pages by clicking their tabs, you will find
that only two of the pages may be accessed without logging in: HOME (default)
and SLAVE INFO; you must log in (click LOGIN) before tabbing to the other
pages, which allow access by permission only: FULL (Administrator), RW
(Read\Write), or R (Read).
• FULL permissions users have access to all pages and all channels and
may configure the interface, set and change security settings, allocate
channels, control the output of the power supply, send commands, etc.
• RW permissions users may access all pages except SECURITY, and may
read and control the output of the power supply for only the channels
allocated to them. They are not authorized to make changes on the IP
CONFIGURATION page.
• R permission users may read information related only to the channels
allocated them, and cannot make any changes or control the output.
Once you have logged in, the LOGIN button becomes a LOGOUT button.
Note: There are few differences between the DCS interface and the DLM
interface: their titles and device names in the banner (see Figure 2-12 and
Figure 2-13), their specifics in the Home page (see Figure 2-15 and Figure
2-16), and the front panel lockout button in the Settings page (see Figure 2-19)
is grayed out for the DCS products. Unless DCS and DLM interfaces are both
shown, the following illustrations use only the DLM interface.
Figure 2-12. DLM Web Page Banner
Figure 2-13. DCS Web Page Banner