AMETEK M130 - Manual (Page 41)

Sorensen Ethernet Option Configuration
M130/M131 Programming Manual 2-23
(Figure 2-22), using the ALLOCATE CHANNELS
capability.
• Output: displays the power output status, ON or OFF
• Trigger: set up by SCPI commands, displays whether the Trigger state is
OFF, ARMED, or TRIGGERED.
• OVP: displays Read Only status of over voltage protection, either OK
(normal) or TRIPPED.
• OTP: displays Read Only status of over temperature condition, either OK
(normal) or TRIPPED.
• Command Error: displays command and syntax errors that are queued
in the supply.
• Read Next Error: each click brings the next error into the Command
Error display, until no other errors are in the queue.
• CLEAR MESSAGES: click this button to clear the Command Error
message window of past messages.
• Last Calibration Date: displays the date that the power supply
(instrument) was last calibrated; configurable with SCPI commands,
normally at the time of calibration.
• Next Calibration Date: displays the date that the power supply should be
calibrated next; also configurable with SCPI commands, normally
calculated at time of calibration.
• Ping Echo: except for Read Only users, allows turning echo ability On or
Off, depending on whether or not you want the supply to respond to a
Ping command from another device on the network. The default setting
for Ping Echo is response enabled. Click the OFF radio button if you do
not want the supply to respond to a ping.
• Ping Remote IP Address: allows you to input an IP address of another
device in the system
• Ping: click this button to ping the device at the address that you entered
in the Ping Remote IP Address field.
• Response: displays the result of your ping. For Example, if the Ping
Address were 69.36.230.190, the Response window would display:
Pinging :69.36.230.190 Response Took 0 ticks
Or
Ping Failed (if the host specified is not in the network)
• CLEAR RESPONSES: click this button to clear the Response window of
past ping responses.