AMETEK M130 - Manual (Page 46)

Configuration Sorensen Ethernet Option
2-28 M130/M131 Programming Manual
SLAVE INFO
This page displays information only for the power supplies configured in this
system (one master power supply with a single IP address and up to 30 slave
power supplies – M131 and/or M85). The information for each power supply
displayed includes the Channel number (1 is the Master; 2 through 31 are
Slaves), the model number, the serial number, and the firmware revision.
Figure 2-26. Slave Information Page
Upon first entering this page, you will see information only for the slaves with
which the master established communication during the present session. Click
REFRESH SLAVE DATA to see the information on the remaining slaves present
in this system. (This refresh operation could take up to 60 seconds).