Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 83)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
7-11
7.3 Recommissioning
7 Commissioning
7.3.3.3 Download configuration from SD card to safety card
Download configuration from SD card to safety card 7- Inbetrieb_Konf_uebertragen_Tool_SD_Karte_Hinweis
Before carrying out the steps described in this section, please note the
following safety guidelines:
Inbetrieb_Konf_uebertragen_SD_Karte_Sicherheitskarte
The safety card's configuration data can be downloaded to the safety
card from an SD card inserted in the servo amplifier, without using the
Configurator.
During this process, the firmware for the servo amplifier is also reloaded.
Prerequisite:
 The following files must be available on the SD card ( or ):
– default.pdis: Configuration file for the safety card
– default.bin or default.s19: Firmware for the servo amplifier
– default.par: Parameter file for the servo amplifier
INFORMATION
Further information is available in the safety card Configurator's
online help.
CAUTION!
Make absolutely sure that the SD card with the safety card con-
figuration is inserted into the read device of the correct servo
amplifier. If not, invalid parameter settings (e.g. limit values) may
lead to unexpected movements and hazardous situations for
either people or equipment.
When the configuration is downloaded from the SD card, the
servo amplifier does not check the safety card configuration, nor
does it check that the configuration is assigned correctly to a
specific safety card.
After swapping the safety card, check that the safety functions
are activated correctly.
4
3 6