Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 80)

7.3 Recommissioning
7 Commissioning
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
7-8
Betrieb_Neustart_CLRFAULT_ab_5_24
7.3.3 Swap safety card
Swap safety card 7- Inbetrieb_Geraetetausch_Allgemein_Pilz
When swapping the safety card, please note the following:
 If the firmware version has changed, configured functions and stated
parameters may no longer be supported or may have been modified.
Adapt the configuration in the Configurator PASconfig SDrive.
 You will need to download the configuration to the safety card again.
Please note down the serial number of the new safety card.
 We recommend that you swap the whole unit (servo amplifier with
safety card). Please contact Pilz.
Montage_EMV ESD
Inbetrieb_Geraetetausch
After swapping the safety card, following a defect for example, you will
need to download the configuration data to the safety card again.
You can download the configuration data to the safety card as follows:
 From the Configurator to the safety card via the servo amplifier's
communications interface (RS 232 or Ethernet).
 From an SD card in the servo amplifier to the safety card.
INFORMATION
Further information on the command can be found in the servo
amplifier's online help, on the "Motion Control" CD (file
ascii_dd5-protego.chm
). Please also refer to the operating
instructions for the servo amplifier.
INFORMATION
Availability of this function: From firmware version 5.24 of the
servo amplifier.
CAUTION!
Damage due to electrostatic discharge!
Electrostatic discharge can damage components. Ensure
against discharge before touching the product, e.g. by touching
an earthed, conductive surface or by wearing an earthed arm-
band.
1
4