Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 73)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
7-1
7.1 Safety guidelines
7 Commissioning
77000 Commissioning Commissioning 7- 7.1 Safety guidelines 7100 Safety guidelines 7- Inbetrieb_Sicherheit
When commissioning/recommissioning, please note the following:
 Secure the site in accordance with the regulations (barrier, warning
signs etc.). The system may only be commissioned/recommissioned
by qualified personnel.
 Please refer to the information and specifications stated in the oper-
ating manual of the relevant programmable control system.
 During commissioning/recommissioning, make sure that no personal
injury and/or material damage can occur, even if the plant/machine
moves unintentionally.
 When commissioning the safety card, please read the safety guide-
lines in the "Commissioning" chapter in the instructions for the servo
amplifier.
][Verdr_nie_unter_Spg_2
Inbetrieb_Start_Warnung_Pilz
DANGER!
Risk of electrocution!
Never wire the electrical connections on the servo amplifier
while voltage is applied.
Switch off the mains voltages and 24 V supply!
Make sure that the control cabinet is made safe, e.g. through an
access lock or warning signs. Do not switch on the voltages until
the system is commissioned!
WARNING!
Threat to life from the motor starting up automatically!
The motor can be set in motion immediately if the option to "Set
software enable when booting [AENA]" is set in the commission-
ing software PDrive:
 After the safety card has run up
 When recommissioning after an error
Take appropriate measures to ensure that no hazardous situa-
tions arise due to the motor starting up.