Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 78)

7.3 Recommissioning
7 Commissioning
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
7-6
Key
:
 Servo amplifiers
– 24 V: Supply voltage
– BTB/RTO: Relay contact for operational readiness, servo amplifier
– L1, L2, L3: Mains voltage
– X8: Intermediate circuit
– STO-ENABLE: Start interlock
– HW-/SW-Enable: Hardware and software enable
– Enable U, V, W: Motor connection
– Motor n: Motor speed
– t
1
: Servo amplifier's run-up time
– t
2
: Load time, intermediate circuit capacitance
– t4: Processing time until servo amplifier is enabled
 Safety card
– 24 V: Supply voltage
– SS1 Activate: SS1 activated
– SS1 SIL3/Reset: Input for SIL3 and reset
– Ready: Operational readiness
– STO Acknowledge: Status: STO activated
– t3: Safety card's run-up time
7.3.2 Recommissioning after error
Recommissioning after error 7- Inbetrieb_Wiederinbetrieb_nach_Fehler
This section describes the recommissioning process after an error has
occurred.
Rectify the error, noting:
 The error messages in the error stack
 The LED display.
Betrieb_Neustart_nach_Fehler_S1
Perform a reset as follows:
 Switch inputs "SS1 Activate" or "SS1 SIL3/Reset"
or
 Run the command "CLRFAULT"
7.3.2.1 Switching the inputs "SS1 Activate" or "SS1 SIL3/Reset"
Switching the inputs "SS1 Activate" or "SS1 SIL3/Reset" 7- Betrieb_Neustart_S1
1. Switch input "SS1 Activate" or "SS1 SIL3/Reset" to 0 V
 The safety card performs the safety function SS1 (Safe Stop 1) and
switches to a "STOP" condition. The "FAULT" LED flashes.