Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 7)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
1-1
1.1 Validity of the documentation
1 Introduction
1 1000 Introduction Introduction 1- 1.1 Validity of the documentation 1100 Validity of the documentation 1- Einf Gltigkeit der Dokumentation
This documentation is valid for the product PMCprimo C. It is valid until
new documentation is published.
][BA_Einfhrung_Einleitung
This operating manual explains the function and operation, describes
the installation and provides guidelines on how to connect the product
PMCprimo C.
Einf_Dokumente
Please also refer to the following documents from the motion control
range:
 The online help for the PDrive commissioning software describes how
to set the parameters for the servo amplifiers from the PMC product
area.
 Guidelines regarding installation and environmental conditions can be
found in the operating manual for the servo amplifier PMCprotego D.
 The configuration and programming software for motion control de-
vices (e.g. CoDeSys, PTerm, PScope, PMotion) can be found on the
CD-ROM "Motion Control Tools".
 The manuals for Pilz products from the PMC product area are availa-
ble on the supplied CD-ROM "Documentation Motion Control".
You will need to be conversant with the information in these documents
in order to fully understand this manual.
1.1.1 Retaining the documentation
Retaining the documentation 1- Einf Aufbewahren
This documentation is intended for instruction and should be retained
for future reference.