Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 48)

7.2 Commissioning the PMCprimo C
7 Commissioning
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
7-4
Establish the connection
1. Open the terminal program PTerm .
2. Select File -> Connect .
The Connect via … window opens.
You can now connect to a known network subscriber. If you do not
know the IP address, you can browse the network for subscribers.
Inbetrieb_primo_C_PC_alt1
Alternative 1: The IP settings are known
 Prerequisite: The PMCprimo C and PC must be accessible in the
same network or via a Router
1. Select New…
The New Connection window opens.
2. Select Ethernet Connection .
The Select Telnet Connection window opens.
3. Enter the IP address and select OK .
The Connect via… window opens. The network subscribers are list-
ed. The network subscriber that has just been entered is highlighted
in the list of connections.
4. Select Connect .
The network subscriber is connected
Inbetrieb_primo_C_PC_alt2
Alternative 2: The IP settings are unknown
 Prerequisite: The PMCprimo C and the PC are in the same broadcast
domain.
1. Select Search… in the Connect via… window
The system searches for network subscribers. The PMCprimo Net-
work Search window opens.
2. From the list, select the subscriber to which you wish to connect.
Please note: Click on Ping to identify the device's hardware.
3. Select Configuration… The Device Configuration window opens.
4. Enter the IP settings and then select OK . The PMCprimo Network
Search window opens.
5. Select Connect .
The network subscriber is connected.
Inbetrieb_primo_C_status
The motion controller reports on the configuration, once the Ethernet
connection has been established.