Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 59)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
8-3
8.1 Operating states and changes in operating status
8 Operation
8.1.2.4 "RUN" operating status
"RUN" operating status 8- Betriebszustand_RUN_primo_C
In "RUN" operating status
 All system sections are in a RUN condition and are operating fault-
lessly.
 A PLC user program is run as part of each cycle.
Status of LED:
 The LED flashes slowly.
8.1.2.5 "STOP" operating status
"STOP" operating status 8- Betriebszustand_STOP_primo_C
In "STOP" operating status
 No user program is run.
 It is possible to communicate with the motion contoller in the terminal
program PTerm via the command language.
Status of LED:
 The LED is lit continuously.
8.1.2.6 "Fatal Error" operating status
"Fatal Error" operating status 8- Betriebszustand_Fatal_Error_primo_C
"Fatal Error" operating status is reached when an error occurs.
 The operating status is adopted temporarily.
 The motion controller automatically changes back to "Startup" oper-
ating status.
 The error is entered in the error stack.
Status of LED:
 The LED is switched off.