Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 53)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
7-9
7.2 Commissioning the PMCprimo C
7 Commissioning
2. Change the entries.
If necessary, you can change the following fields, for example:
– Name: Identification for servo amplifier
– Maximum mains voltage: 230 V, 400 V or 480 V
Select motor from motor database
 Select Tools -> Motor Database…
The Pilz Motor Database window appears. You can select a suitable
motor for a certain servo amplifier.
Send parameter file to servo amplifier

Click Apply to send the parameter file to the servo amplifier.
7.2.5 Operate PMCprimo C
Operate PMCprimo C 7- Inbetrieb_bedienen_primo
You can operate the motion controller in PTerm by issuing commands
in the command language.
HW1 - Show Hardware
0.1: hw1
0.1:
SOFTWARE
Firmware: 3.0.2_T04, Apr 18 2012, 15:49:14
Motion: INSTALLED
IEC PLC: INSTALLED
Interpolation: NOT AVAILABLE
ETHERNET
IP address 192.168.0.12
Netmask 255.255.255.
0
Gateway 192.168.0.1
CHANNELS
Number 1...30
HARDWARE
Type: PMCprimo C 600MHz CAN/CAN
Mat.Nr.: 680050