Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 66)

8.3 Functions of the reset button
8 Operation
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
8-10
8.3 Functions of the reset button 8300 Functions of the reset button 8- Reset_Taster
The "RESET" button is mounted in a recess on the front of the unit. It can
only be accessed using an appropriate tool (e.g. a pin).
The following actions can be triggered by pressing the "RESET" button:
 Change from "Startup" operating status to "Boot Menu"
 Hardware reset (cold start): Change from "RUN" or "STOP" operating
status to "Startup"
 Change from "RUN" operating status to "STOP"
 Change from "STOP" operating status to "RUN"
Change from "Startup" operating status to "Boot Menu"
After cold starting the motion controller you can change to the "Boot
Menu" in order to set the operating parameters.
Proceed as follows:
 The controller is in "Startup" operating status. LED flashes rapidly.
 The LED lights for 4 s continuously after "Startup" has been run. Dur-
ing this time it's possible to change to "Boot Menu" operating status.

Press the reset button while the LED is lit continuously.
 The controller changes to "Boot Menu".
Hardware reset (cold start)
A hardware reset can be triggered in "RUN" or "STOP" operating status.
The controller changes to "Startup" operating status.
Proceed as follows:
 The controller is in "STOP" or "RUN" operating status.
 Hold the reset button down for at least 4 s.
 The controller changes to "Startup".
Changing between the operating states "RUN" and "STOP"
You can change between the operating states "RUN" and "STOP".

Briefly press the reset button to change from "RUN" to "STOP" or
from "STOP" to "RUN".