Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 33)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
6-1
6.1 Wiring guidelines
6 Wiring
6 6000 Wiring Wiring 6- 6.1 Wiring guidelines 6100 Wiring guidelines 6- Verdr_Leiterquerschnitte
Please note:
 Cable cross sections for field connection terminals in mm
2
:
– Digital inputs/outputs, supply voltage: 0.5 (AWG20) ... 1.0
(AWG18), AEH without plastic collar, in accordance with DIN
46228/1
Verdr_Allgemein
Inputs
 Appropriate wiring must be used to exclude short circuits between
the inputs or to a supply line!
 Cables must be shielded if the signals are used as reference inputs.
Other signal lines do not need to be shielded.
Outputs
 If short circuits occur between the cable from the output to the load
and a supply line, it will no longer be possible to switch off the load.
Possible remedy: Use separate multicore cable for supply voltages.
 Use appropriate wiring to exclude short circuits between the outputs!
 The actuators may be connected using unshielded cables.
 The outputs do not need suppression for inductive loads.
Cable material
 Use copper wiring.