Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 32)

5.4 Installing the fieldbus junction box
5 Installation
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
5-4
5.4 Installing the fieldbus junction box 5400 Installing the fieldbus junction box 5- Montage_Feldbusverteiler
A fieldbus junction box is included with the PMCprimo C. The fieldbus
junction box is plugged into the servo amplifier.
To install the fieldbus junction box, follow the instructions below:
 Switch off the mains voltages and 24 V supply!
 Connect the 9-pin female D-Sub connector X6D to the male connec-
tor X6 on the servo amplifier.
 Turn the screws into the thread on the housing.
Montage_Feldbusverteiler_Abb
Fig. 5-3: Installing the fieldbus junction box on a servo amplifier
INFORMATION
Pin assignment, wiring and assembly are described in the oper-
ating manual for the fieldbus junction box.
START RESET
X45
X6D
X6