ADLINK PCI-8102 - Manual (Page 73)

62 Operations
4.2.12 Manual Pulser Function
Manual pulser is a device to generate pulse trains by hand. The
pulses are sent to motion controller and re-directed to pulse output
pins. The input pulses could be multiplied or divided before send-
ing out.
The motion controller receives two kinds of pulse trains from man-
ual pulser device: CW/CCW and AB phase. If the AB phase input
mode is selected, the multiplier has additional selection of 1, 2, or
4.
The following figure shows pulser ratio block diagram.