ADLINK PCI-8102 - Manual (Page 195)

184 Connection Example
Notes:
1. Servo & Stepper: The DIN-68M-J3A provides 2 connection
methods for each axis: CN1F1 & CN1F2 connectors for
Mitsubishi J3A series servo drivers, and a SJ connector for
stepping drivers. DO NOT use both connectors at the same
time.
2. CN1F1 or CN1F2 cables: One pin-to-pin 50-PIN cables are
required for connection between the CF1F1(CN1F2) and the
Mitsubishi J3A driver. It is available from ADLINK, or users
may contact the local dealer or distributor to get cable infor-
mation.
3. JP1: Fuse selection. Pin 1-2 short means the board is pro-
tected by fuse. Pin 2-3 short means the board is not protect-
ed by fuse.
4. Fuse: The fuse protects from damaging internal circuit. This
fuse can sustain 2A current. Users can buy it in local area
when the fuse is burnt out.