Area information, 1  area information, 2  exit delay – DMP Electronics DMP Command Processor Panel XR500 User Manual
Page 53: 3  burglary bell output, 4  opening/closing reports, Exit delay, Burglary bell output, Opening/closing reports
Digital Monitoring Products
XR500 Series Canadian Programming Guide
44
PC LOG REPORTS
17.10
DOOR ACS NO YES
Door Access Reports
Sends door access activity: door number, user number and name, and time and date.
17.11
SUPV MSG NO YES
Supervisory Reports
Sends system monitor reports, such as AC and battery, and system event reports.
Supervisory Reports also sends the following reports:
• Abort
• Exit Error
• Ambush
• System Recently Armed
• Alarm Bell Silenced
• Unauthorized Entry
• *Late to Close
* Only sent as a Supervisory Report if
Area Schedules is not enabled, Closing
Check is enabled, and an opening/closing schedule has been programmed.
Note: To send these reports to the PC Log, you must enable SUPV MSG.
17.12
PC Log Real-Time Status
Select YES to send Real-Time Status reports for zones, doors, and outputs. The
specific reports must also be selected by individual zone or output. The Real-Time
Status messages are sent to a PC running a graphic display software. Default is NO.
The messages that can be sent are:
• Door Open with zone number
• Door Closed with zone number
• Door Open with door number
• Door Closed with door number
• Output On
• Output Off
• Output Pulse
• Output Temporal
PC LOG REAL-TIME
STATUS NO YES