DMP Electronics DMP Command Processor Panel XR500 - Manual (Page 34)

XR500 Series Canadian Programming Guide Digital Monitoring Products
25
SYSTEM REPORTS
7.14.1
REMOTE CHANGE IP
Remote Change IP
This option displays when NET is selected for Send Local Changes. Enter the IP
address containing up to 12 digits. The Net IP Address must be unique and cannot
be duplicated on the network. Enter all 12 digits and leave out the periods. For
example, enter IP address 192.168.0.250 as 192168000250. The periods display
automatically. Default is 000.000.000.000
7.14.2
REMOTE CHANGE
Remote Change Port
This option displays when NET is selected for Send Local Changes. Enter the Port
number. Valid numbers are from 0 to 65535. Default is 2002.
7.14.3 Remote Telephone Number
This option displays when DD is selected for Send Local Changes. Press COMMAND to
enter the phone number the panel dials when sending programming changes. After
entering a phone number, the panel sends any panel changes to Remote Link.
The phone number can have two lines of 16 characters each to equal 32. Enter a
P to program a two second pause in the dialing sequence. The P character counts
as part of the 32 allowable characters. Enter *70P as the string first characters to
cancel call waiting. Dial tone detect is an automatic panel function.
System Reports
8.1 SYSTEM REPORTS System Reports
Select specific system reports the panel sends to the receiver.
8.2 ABORT NO YES Abort Report
YES allows the panel to send an alarm abort report to the receiver any time an area
is disarmed during Transmit Delay before an alarm report is sent and the Bell Cutoff
Time has not expired. After disarming an area, if any other area remains armed and
has zone(s) in alarm, the alarm abort report is not sent.
If the communication type is set to DD, a Warning: Alarm Bell Silenced report is also
sent if the alarm bell is silenced.
Note: Abort Reports are not sent for Fire, Fire Verify, or Supervisory type zones.
8.3 RESTORAL: YES Restoral Reports
This option allows you to control when and if a zone restoral report is sent to the
central station receiver. Press any Select key to display the following options:
NO YES DISARM
NO - Disables the zone restoral report option. Zones continue to operate normally
but do not send restoral reports to the receiver.
YES - Enables the zone restoral report option. Zone restorals are sent whenever a
zone restores from a trouble or alarm condition.
DISARM - Causes the panel to send restoral reports for a non-24-hour zone whenever
a zone that has restored from a trouble or alarm condition is disarmed. All 24-hour
zones send restoral reports as they restore.
8.4 BYPASS NO YES Bypass Reports
YES allows the panel to send all zone bypasses, resets, and force arm reports to the
receiver. The bypass report includes the zone number, zone name, and the user
name and number of the individual operating the system. Reports are only sent if
O/C User in Communications is set YES for Receiver 1 or Receiver 2.
8.5 SCHD CHG NO YES Schedule Change Reports
YES allows the panel to send all schedule changes to the receiver. The report
includes the day, opening time, closing time, extend schedule time, and the user
name and number of the individual making the change. Schedule changes made
through Remote Link™ are not sent to the printer or Display Events.
000.000.000.000
PORT: 2002
REMOTE PHONE NO.
-
-