DMP Electronics DMP Command Processor Panel XR500 - Manual (Page 23)

Digital Monitoring Products XR500 Series Canadian Programming Guide
14
MESSAGING SETUP
Messaging Setup
5.1 MESSAGING SETUP Messaging Setup
This section allows you to enter the information needed to receive messages
directly from the panel via email and In Touch™ SMS Text using Network or Cellular
communication. All of the name and password options below allow up to 32
lowercase characters to be entered. The Destination addresses allow up to 48
characters to be entered. System Name is displayed with initial caps.
The transmitted messages are:
• Zone Alarms by Zone Name
• Zone Troubles by Zone Name
• Zone Bypass by User
• Arming (Closings) by User
• Disarming (Openings) by User
• Late to Close
• AC Power Trouble and Restoral
• System Low Battery
• Ambush
• Abort, Cancel and Alarm Verified by User
• Check-in by user
5.2 Enable Messaging
Select YES to allow the panel to send messages to three programmed destinations.
Default is NO.
5.3
SYSTEM NAME
System Name
Enter a unique name for the panel. The panel name is used as the sender of the
message. The text entered is displayed with initial caps. If this field is left blank, the
panel account number is sent.
5.4 DESTINATION 1 Destination 1
-
Enter the first email address or cell phone number where messages will be sent. The
message can be sent to any device (computer, cell phone, PDA) as long as a valid
email address or cell phone number is entered. When entering email addresses,
press the 7 digit key followed by the fourth Select Key to add the @ symbol and the
9 digit key followed by the fourth Select Key to add the _ symbol. See the Entering
Non-Alpha Characters section for additional symbols.
Note: Mail servers that require Transport Layer Security (TLS) encryption are not
supported by the XR500 Series.
5.5 Destination 1 User Number
If Destination 1 is a 10-digit cellular number, enter a user’s user number from this
account. This option is used when sending commands such as arming or disarming
back to the panel using In Touch™ SMS Text from the same cell phone or PDA. The
user number must have the authority to perform the commands as if it occurred at the
keypad. In Touch™ SMS Text command operation is available in XR500 Series panels
using version 205 or higher. Entering 0 (zero) disables this option. Default is 0.
5.6 DESTINATION 2 Destination 2
-
Enter the second destination email address or cell phone number.
5.7 Destination 2 User Number
If Destination 2 is a cellular number, enter the user’s User Number for
arming/disarming authorization.
5.8 DESTINATION 3 Destination 3
-
Enter the third destination email address or cell phone number.
ENABLE MESSAGING
NO YES
-
DESTINATION 1
USER NUMBER: 0
DESTINATION 2
USER NUMBER: 0