TeeJet Matrix Pro 840GS - Manual (Page 68)

62
www.teejet.com
HOME
OVER
VIE
W
SE
TUP
IMPLEMENT
FULL SCREEN
GPS
INTR
ODUC
TION
GUID
ANCE
DR
OPLE
T MONIT
OR
Straight implement type
1. Select Straight implement type on implement screen.
2. Press NEXT PAGE arrow .
3. Select from:
►Boom offset direction – used to select whether the boom is
located in front of or behind the GPS antenna as the vehicle
moves in a forward direction
►Antenna to boom distance  – used to enter the distance
from the GPS antenna to the boom. Range is 0.0 to
50.0 metres.
►Overlap – used to select the amount of overlap allowed
when the sections are turned on and off while using
automatic boom section control
►Delay on time – used to set the time when each section
will switch on when entering an area that has not been
applied. If the application turns on too soon when entering
an unapplied area, decrease the delay on time. If the
application turns on too late, increase the delay on time.
Range is 0 to 10 seconds.
►Delay off time – used to set the time when each section will
switch off when entering an area that has been applied. If
the application turns off too soon when entering an applied
area, decrease the delay off time. If the application turns
off too late, increase the delay off time. Range is 0 to
10 seconds.
4. Press RETURN arrow to return to the implement screen
or CONFIGURATION side tab to return to the main
configuration screen.
Figure 8-15: Implement setup options in straight mode
Figure 8-16: Overlap
100% 50% 0%