TeeJet Matrix Pro 840GS - Manual (Page 54)

48
www.teejet.com
HOME
OVER
VIE
W
SE
TUP
IMPLEMENT
FULL SCREEN
GPS
INTR
ODUC
TION
GUID
ANCE
DR
OPLE
T MONIT
OR
smartCable or section driver Module
If a SmartCable or Section Driver Module (SDM) is present,
BoomPilot is used to set automatic section control to off/
manual , automatic or all on .
NOTE: If a SmartCable or Section Driver Module (SDM) is not
present, please refer to Single section to view example.
GPS is unavailable when the BOOMPILOT icon
is grey . BoomPilot status bar icon will be off/
manual .
Figure 6-41: Automatic to all sections on mode
7.2
km/h
2.07
ha
> 0.0 <
A
A
Console only
To switch BoomPilot to automatic :
1. Press NAVIGATION AND GUIDANCE OPTIONS tab to
display navigation options.
2. Press BOOMPILOT icon .
◄Automatic – status bar icon will change to green
In areas where application is not desired:
1. Press NAVIGATION AND GUIDANCE OPTIONS tab to
display navigation options.
2. Press BOOMPILOT icon .
◄Off/manual – status bar icon will change to red
Press the BOOMPILOT icon again to resume application.
To turn all sections on :
1. Press NAVIGATION AND GUIDANCE OPTIONS tab to
display navigation options.
2. Press and hold BOOMPILOT icon .
◄All On – Status Bar Icon will change to yellow
Matrix Pro GS Boompilot Switch Configuration
BoomPilot
(ABSC) System
Rate Controller RC with Internal SDM
Work Switch
Spray
Icon Master Boom Switches Master Boom Switches
Automatic Mode On Off On On Off
Manual Mode On On On On Off
Rate controller or Switchbox
To switch BoomPilot between off/manual and automatic
when a rate controller or switchbox in on the system:
1. Turn the rate controller master switch to the “On” position.
The individual boom section switches should remain in the
“Off” position.
2. Press NAVIGATION AND GUIDANCE OPTIONS tab to
display navigation options.
3. Press BOOMPILOT icon .
◄Automatic – status bar icon will change to green
In areas where application is not desired:
1. Press NAVIGATION AND GUIDANCE OPTIONS tab to
display navigation options.
2. Press BOOMPILOT icon .
◄Off/manual – status bar icon will change to red
Press the BOOMPILOT icon again to resume application.
OR
1. Manually turn “off” the rate controller master switch to shut off
the booms.
◄Off/manual – status bar icon will change to red
Turn the master switch “on” to resume application.
To turn all sections on :
1. Press NAVIGATION AND GUIDANCE OPTIONS tab to
display navigation options.
2. Press and hold BOOMPILOT icon .
◄All On – status bar icon will change to yellow
Rate controller with Internal Section Driver Module
When using a rate controller with an internal section driver
module, both the master switch and the boom section switches
need to be in the “On” position..
Work on/off switch
When installed, work on/off switch should remain in the “off”
position for all setup options.