SilentKnight 5808 - Manual (Page 139)

IntelliKnight 5808 Installation Manual 151274-L8
8-13
Trouble
A system
trouble
condition
occurs.
A trouble
condition with
a CO detector
The dialer seizes control of the phone line
and calls the central station.
The on-board annunciator sounds a loud,
pulsing beep in the sequence one second
on, nine seconds off.
SYSTEM TROUBLE LED flashes.
The LCD displays a screen similar to this
one.
Press down arrow to view the trouble. A screen similar to
this one displays.
Press SILENCE and enter an access code (or activate
the key) to silence the annunciator.
Once the trouble condition has been fixed, the system
will restore itself automatically.
After sitting idle, events will display in a screen similar
to this:
Prealarm A single
detector trips
in a 2-Count
zone. (2-Count
means two
detectors must
trip before an
alarm is
reported.) Touchpad PZT beeps.
The LCD displays a screen similar to this
one.
Press (down arrow) to view the prealarm. A screen
similar to this one displays.
All system operations are available in this mode.
After sitting idle, events will display on a screen similar to
this:
Note: Alarm and Prealarm are combined into
a single alarm count.
Table 8-1: Operation Mode Behavior
Operation
Mode
Occurs
When
System Behavior In This Mode You Can