SilentKnight 5808 - Manual (Page 122)

Programming 151274-L8
7-30
revert to standard time on the last Sunday in October at 2:00 a.m. After January 2007, if this feature is enabled,
the system clock will start and end DST according to the settings made in Daylight Savings. If this feature is not
enabled (set to No) the Daylight Saving Time change is not made to the system clock.
To enable or disable DST adjustment continue programming from step 4 above:
1. Select Y (enabled) or N (disabled) by pressing the or arrow, then press ENTER .
7.6.6.2 Daylight Saving Time Start and End
This option lets you to adjust the week and month Daylight Saving Time (DST) starts and ends. For this feature
to work, you must enable (set to Yes) the DST option under Daylight Savings. You can view and change the
settings in this option anytime, however, settings will not take effect until 2007. The default values for the DST
Start and End options reflect the August 8, 2005 DST law that goes into effect in 2007:
DST Start: The second Sunday in March
DST End: The first Sunday in November
To set the start and end for Daylight Saving Time:
1. Press the or arrow to select the week (1st, 2nd, etc.) Daylight Saving Time starts, then press ENTER
to make your selection and move to the month setting.
2. Press the or arrow to select the month (January – December) Daylight Saving Time starts, then
press ENTER to make your selection and move to the DST End option.
3. Press the or arrow to select the week (1st, 2nd, etc.) Daylight Saving Time ends, then press ENTER
to make your selection and move to the month setting.
4. Press the or arrow to select the month (January – December) Daylight Saving Time ends, then press
ENTER two times to make your selection and exit.
7.6.7 Edit Banner Message
The banner is the message that displays on the panel LCD when the system is normal, that is, when no alarms or
troubles exist and no one is currently using system menus. You can create a customized message, which can be
up to 40 characters, two lines of 20 characters each.
If you do not create a customized message, the system will use the internal banner. You cannot change the
internal banner.
To customize the banner display message:
1. Enter the installer code.
2. Select 7 for Program Menu.
3. Select 5 for System Options.
4. Select 8 for Edit Banner.