Reznor MAPS II Unit Installation Manual User Manual
Installation/operation, For your safety, Warning
Table of contents
Document Outline
- 1. General
- 1.1 Cautions and Warnings
- 1.2 General Information
- 1.3 Warranty
- 1.4 Installation Codes
- 3. Receiving, Moving, and Storage
- 3.1 Receiving and Moving
- 3.2 Storage and Installation Checks
- 4. Dimensions and Clearances
- 4.1 Dimensions - Models RCA, RDA, RDCA, RDDA
- 4.2 Dimensions - Models RECA, REDA
- 4.3 Clearances
- 5. Mounting
- 5.1 Approximate Weights
- 5.2 Roof Curb
- 5.3 Curb Heater Section, Model JHUP 250
- 5.4 Rigging and Lifting
- 6. Mechanical
- 6.1 Duct Connections
- 6.2 Condensate Drain
- 6.3 Inlet Air Hood
- 6.4 Blowers, Belts, and Drives
- 7. Electrical and Wiring
- 7.1 General, Wiring Diagram, and Unit Wiring Requirements
- 7.2 Supply Wiring
- 7.3 Disconnect Switch
- 7.4 Control Wiring
- 7.5 Blower Motor
- 7.6 Condenser Fan Motors and Fans
- 7.7 Compressors
- 8. Controls
- 8.1 Digital Control Systems
- 8.2 Remote Console
- 8.3 Control Locations
- 8.4 Miscellaneous Electrical and Control Options
- 9. Optional Equipment including Heat Sections
- 9.1 Inlet Air Control and Energy Recovery Options
- 9.2 Power Exhaust (Building)
- 9.3 Gas Heat Module - Models RDCA and RDDA
- 9.4 Gas-Fired Curb Heater Section, Model JHUP-0250
- 9.5 Electric Heat Section - Model RECA and Model REDA
- 10. Commissioning and Startup
- 10.1 General
- 10.2 Checklist Prior to Startup
- 10.3 Checklist - Startup
- 10.4. Checklist After Startup:
- 10.5 Startup Form
- APPENDIX
- Cross-Reference by Model/Size and Cabinet Size A, B, or C
- Technical Data - Applies to Makeup Air Cooling System in Models RCA, RDCA, and RECA
- Wiring Diagram Option Identification
- Pressure/Temperature Chart for Checking Superheat and Subcooling
- Index
- References (Catalogs and instruction manuals are available for download at www.RezSpec.com.)