Reznor UDBS Option - Installation - Separated Combustion Venting - Manual

Form I-UD-V-SC, PN195676R17, Page 1
APPLIES TO: Venting Requirements for
Model UDAS and Model UDBS and
Instructions for Combustion Air Inlet /
Vent Terminal Options CC6 and CC2
Form I-UD-V-SC (12-14)
Obsoletes Form I-UD-V-SC (Version E.2) ®
General
SEPARATED
COMBUSTION
201216
This manual applies only to venting and combustion air inlet instructions and must
be used with the installation manual that was shipped with the heater. If either
manual is missing, contact your distributor before beginning installation.
Verify that the label near the vent outlet on the heater matches the label illustrated
below. (Label P/N is 201216; color is green.)
WARNING
Installation should be done by a qualified agency in
accordance with these instructions. The qualified service
agency installing this separated-combustion system is
responsible for the installation.
WARNING
Do not use an existing venting system. This heater requires
installation of the combustion air/vent system ordered with
the unit, either Option CC6 or CC14 for a horizontal system
or Option CC2 for a vertical system. Failure to comply could
result in severe personal injury or death and/or property
damage.
Rear View - Model UDAS
CAUTION: Model UDAS and UDBS unit heaters should not be used
in an application where the heated space temperature is below
50°F (10°C). Operating under low ambient conditions may cause
condensate to form in the heat exchanger.