Reznor UDBP Option - Installation - Vertical Louvers - V3 Series - Manual

Form RZ-NA I-V3-VL, P/N 197108R3, page 1
Installation Form for Vertical Louvers,
Option CD1
Applies to: Models UDAP, UDAS, UDBP, UDBS, UEAS
®
Vertical louvers are designed to direct the discharge air to provide a wider throw
pattern. These vertical louver option packages apply to Reznor unit heater Models
UDAP, UDAS, UDBP, UDBS, and UEAS as listed in the table below.
Description and
Application
Installation
Instructions
WARNING: Improper installation, adjustment, alteration, ser-
vice, or maintenance can cause property damage, injury or
death. Read the installation, operation, and maintenance
instructions thoroughly before installing or servicing this
equipment.
Installation should be done by a qualified agency in accordance with these instruc-
tions and in compliance with all codes and requirements of authorities having
jurisdiction.
1. Assemble the Vertical Louver Frame (See FIGURE 1.)
Using the screws in the kit, attach both sides to the top. (NOTE: Top and bottom
are identical.) Attach the assembly to the bottom creating a frame.
FIGURE 1 - Assemble
the Louver Frame
Components
Assemble
louver frame
with screws.
Louver Frame Side
(parts are identical)
Louver Frame
Top or Bottom
(parts are identical)
Form I-V3-VL (Version A.1)
Obsoletes Form I-UD-VL (Version A)
Models UDAS, UDAP,
UDBP, UDBS
30, 45 60, 75 100, 125
150, 175,
200
225, 250
300, 350,
400
Model UEAS 130, 180 260, 310
Option Pkg P/N 197097 197098 197099 201199 201200 201201
Components - (qty) and P/N
Louver Frame Top and
Bottom
(2)197056 (2)197189 (2)197190
Louver Frame Sides (2)197057 (2)197058 (2)197059 (2)197186 (2)197187 (2)197188
Screws
(20) 195638, #8-18 x 3/8" long, AB point, slotted indented serrated hex
washer head
Louvers (5)196232 (5)196231 (5)196233 (8)196572 (8)196573 (8)195315
Compression Springs (5)195046 (5)195046 (5)195046 (8)195046 (8)195046 (8)195046