Reznor MAPS II Unit Installation Manual - Manual (Page 3)

Form I-MAPS II, P/N 206131 (Rev 13), Page 3
Model Description
RCA Makeup Air Cooling Packaged System, 800-10000 CFM
RDCA
Makeup Air Cooling Packaged System, 800-10000 CFM, with Gas
Heat Section (100-700 MBH)
RECA
Makeup Air Cooling Packaged System, 800-10000 CFM, with
Electric Heat Section (5-88 kw)
RDA
Makeup Air Cooling and Dehumidification Reheat Cycle Packaged
System, 800-10000 CFM
RDDA
Makeup Air Cooling and Dehumidification Reheat Cycle Packaged
System, 800-10000 CFM, with a Gas Heat Section (100-700 MBH)
REDA
Makeup Air Cooling and Dehumidification Reheat Cycle Packaged
System, 800-10000 CFM, with an Electric Heat Section (5-88 kw)
JHUP Supplemental Gas-Fired Duct Furnace
WARNING:
Gas-fired appliances are not designed for use in hazardous
atmospheres containing flammable vapors or combustible
dust, in atmospheres containing chlorinated or halogenated
hydrocarbons, or in applications with airborne silicone
substances. See Hazard Levels, above.
WARNING:
Should overheating occur, or the gas supply fail to shut
off, shut off the manual gas valve to the appliance before
shutting off the electrical supply.
WARNING:
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and replace any gas control that has been
under water.
Warnings for Models
RCDA and RDDA with
Gas Heat Section
1.2 General
Information
Read this booklet and become familiar with the installation requirements of your
particular model. If you do not have knowledge of local requirements, check
with the local agencies who might have requirements concerning this installa-
tion. Before beginning, make preparations for necessary supplies, tools, and
manpower.
Some information is by cabinet size; see cross-reference table in the APPEN-
DIX, page 58.
This booklet includes installation and operation information. Before beginning
any procedure, carefully review the information, paying particular attention to
the warnings. Handling of refrigerant should only be performed by a certified
HVAC technician in compliance with all codes and requirements of authorities
having jurisdiction.
The instructions in this manual apply to the following MAPS
® II models: