Restoring default settings, Viewing system information – Interlogix NVR 50 User Manual User Manual
Page 129
14BChapter 15: NVR management
TruVision NVR 50 User Manual
123
Restoring default settings
To restore the default factory settings of the NVR:
1. Click the
System Settings
icon in the menu toolbar and select
Configuration
.
2. Click the
Default
tab. Click
OK
to confirm you want to restore default settings.
Note: Network information such as IP address, subnet mask, gateway, MTU,
NIC working mode, server port and default route are not restored to factory
default settings.
Viewing system information
To view system information:
1. Click the
System Settings
icon in the menu toolbar and select
System
Information
.
2. To view device information, click the
Device Info
tab.
3. To view camera information, click the
camera
tab.