Interlogix NVR 50 User Manual - Manual (Page 111)

11BChapter 12: Network settings
TruVision NVR 50 User Manual 105
3. Click Apply to save the settings.
Configuring the server and HTTP ports
You can change the server and HTTP ports from the default settings in the
Network Settings screen. The default server port is 8000 while that of the default
HTTP port is 80.
Note: The server port has a port range of 1024 to 65535 and is used for remote
client software access. The HTTP port is used for remote internet browser
access.
To change the default ports:
1. Click the Network Settings icon in the menu toolbar and then click More
Settings .
2. Enter the new Server Port and HTTP Port values.
Configuring the RTSP service port
The RTSP (Real Time Streaming Protocol) is a network control protocol
designed for use in entertainment and communications systems to control
streaming media servers.
To configure RTSP service port:
1. Click the Network Settings icon in the menu toolbar and then click More
Settings .
2. Enter the RSTP port value. The default value 554.
Checking network status
You can easily check network traffic in order to obtain information about the NVR
such as its linking status, MTU, sending/receiving rate, MAC address, and NIC
type.
You can also check the network connection status by testing its delay and packet
loss.
To check network traffic:
1. Click the System Settings icon in the menu toolbar and then click Net detect
to display the Traffic screen. The information displayed is refreshed once a
second.