DVR systems PSS ENG User Manual

Page 74

invalid if you have checked the box

in chapter

3.7.5.2 Option.

 Output alarm activation video to: This function allows you to output the alarm activation

video to the specified output device (besides display in the PSS interface). Please check the

box to enable this function first. Then you can select a device(NVD/SNVD) and monitor from

the dropdown list respectively. Please make sure you have enabled

in chapter 3.7.5.2 Option, otherwise this

function is disabled.

 Alarm sound continuous time: Here you can check the box first to enable this function and

then input the corresponding last time. The input value ranges from 5o to 30 seconds. The

alarm sound can last for the specified time if you enabled this function. You need to cancel

the alarm sound manually once you disabled this function here.

Section 3

 Apply: Click it to apply current setup.

Section 4

 Alarm arm enable: You can enable this function to use alarm setup. Otherwise the alarm

setup is null.

For IVS mode, you can see there is intelligent alarm pane. It is to set to enable the audio or add

the alarm record to the alarm record window. See Figure 3-95.

Figure 3-95

Arm/Disarm

Arm/disarm interface is shown as in Figure 3-96.