DVR systems PSS ENG - Manual (Page 39)

33
valid. Click the "enable tour" button again,
system begins to display in the pane 3 again.
 When you switch from the SPOT mode to the
VGA/HDMI/BNC output mode, system
automatically disable current SPOT plan and
begin the plan of the VGA/HDMI/BNC.
Output Configuration
Click it you can view the detailed setup information. See Figure 3-40.
 Select port: There are also two modes: SPOT output and the VGA/HDMI/BNC output. The
setup here is for the following tour setup plan. Once you select VGA/HDMI/BNC output, the
following tour setup and video mode is for VGA/HDMI/BNC output mode only. Your setup in
pane 2 of Figure 3-39 is for preview play mode only.
 Tour enable: After you enabled the tour function, you can select various modes to begin the
tour. There is only one status available if you have not enabled the tour function, other
operations are all null.
 Window-mode configuration: In pane 3 of Figure 3-39, you can view the local output effect. It
supports 1/4/9/16-window mode. You can select in the following interface.
 Resume default: Current setup can become the default mode after you clicked this button.
Figure 3-40
Click OK button in Figure 3-, you can see the following dialogue box. See Figure 3-41. Click OK
button, system will exit current interface (Figure 3-40) and simulate current display mode in the
pane 3 of Figure 3-39. It will also save current setup as the default mode.
Figure 3-41