ThingMagic M5e-Compact User Manual
Page 30
Regional Support
30
Functionality of the Embedded Modules
Supported Regions
The regional functionality is set using a single serial command,
Setting the Region configures the regional default settings including:
Loads the Frequency Hop Table with the appropriate table for the selected region.
Sets the PLL frequency to the first entry in the hop table, even if the RF is off.
Selects the transmit filter, if applicable.
Executes the Listen Before Talk (LBT) algorithm in supported regions, using the
defaults specified below or the user specified values when calling
.
Region
Regulatory Support
M5e
M5e-C
M5e EU
North America (NA)
FCC 47 CFG Ch. 1 Part 15
Industrie Canada RSS-210
Yes
Yes
No
European Union (EU)
ETSI EN 302 208
Yes
Yes
Yes
European Union
(EU2)
ETSI EN 300 220
Yes
Yes
Yes
European Union
(EU3)
Revised ETSI EN 302 208
Yes
Yes
Yes
Korea (KR)
MIC
Yes
Yes
No
Korea (KR2)
KCC (2009)
Yes
Yes
No
India (IN)
Telecom Regulatory Authority of
India (TRAI), 2005 regulations
Yes
Yes
Yes
1
People’s Republic of
China (PRC)
SRRC, MII
Yes
Yes
No
Australia (AU)
ACMA LIPD Class Licence Varia-
tion 2011 (No. 1)
Yes
Yes
No
New Zealand (NZ)
Radiocommunications Regula-
tions (General User Radio
Licence for Short Range Devices)
Notice 2011
Yes
Yes
No
Open Region
No regulatory compliance
enforced
Yes
Yes
Yes
Note:
1- Under the current PRC regulations the module alone should berestricted to an output
power setting of +21dBm or below. However, the exact maximum power setting is determined
when the device in which the module is installed, and the module, is tested as a system.