ThingMagic M5e-Compact - Manual (Page 181)

Get Application Commands
Command Set 181
Get Reader Configuration(6Ah)
For the previous version of this command see Appendix D: Get Reader Configuration(6Ah)
The Get Reader Configuration command returns the current reader configuration for
the setting specified by the key field as defined in
Set Reader Configuration(9Ah) when
using Option=0x01. When using Option=0x00 it will use the previous format of the
command.
Send the following command to get the current Unique Read setting:
The example reply shows the current configuration setting:
Get Protocol Configuration (6Bh)
The Get Protocol Configuration command is used to get current protocol-specific
configuration parameters settings as specified in
Set Protocol Configuration (9Bh) .
Send the following command to get the current Gen2 Session configuration parameter
value:
The example reply shows the Gen2 session is set to S2 (0x02):
FF 01 69 00 00 01 97 8F
SOH Length OpCode Status User Mode CRC
FF 02 6A 01 00 2E 4E
SOH Length OpCode Option Key CRC
FF 03 6A 00 00 01 00 01 AF 5C
SOH Length OpCode Status Option Key Value CRC
FF 02 6B 05 00 3A 6F
SOH Length OpCode Protocol Parameter CRC