ThingMagic M5e-Compact - Manual (Page 161)

Set Application Commands
Command Set 161
Note
When LBT is disabled in the Open region the M5e/M5e-Compact will
implement frequency hopping as implemented for the NA region with a
frequency hop interval of 400ms.
Set Power Mode (98h)
The Set Power Mode command can set the M5e to four different power management
modes. See
Available power modes .
Use the Set Power Mode command to set the power mode to maximum saving mode by
sending the following:
Set User Mode (99h)
Use the Set User Mode command to set the user mode to the type of application in
which the M5e will be configured for the optimal GEN2 and Search Strategy settings.
Setting the User Mode to an unsupported value will not modify the current setting.
Available Gen2 User Modes
Send the following to set the user mode to printer:
FF 01 98 03 44 BE
SOH Length OpCode Power Mode CRC
Value User Mode Session Target M
Q Value (Static/
Dynamic)
0x00 NONE (Default) 0 A only 4 InitQ=2 (Dynamic)
0x01 PRINTER 0 A only 4 InitQ=2 (Dynamic)
0x02 Unsupported
0x03 PORTAL 1 A only 4 InitQ=3 (Dynamic)
FF 01 99 01 45 BC
SOH Length OpCode User Mode CRC