Fault_protocol_kill_failed - 40eh, Cause, Solution – ThingMagic M5e-Compact User Manual
Page 225: Fault_protocol_bit_decoding_failed - 40fh, Fault_protocol_invalid_epc – 410h, Fault_protocol_invalid_num_data – 411h
Protocol Faults
Appendix C: Error Messages
225
FAULT_PROTOCOL_KILL_FAILED - 40Eh
Cause
Attempt to kill a tag failed for an unknown reason
Solution
Check tag is in RF field and the kill password.
FAULT_PROTOCOL_BIT_DECODING_FAILED - 40Fh
Cause
Attempt to operate on a tag with an EPC length greater than the Maximum EPC length
setting.
Solution
Call
to set the Max EPC to 496 bits..
FAULT_PROTOCOL_INVALID_EPC – 410h
Cause
This error is used by the M5e GEN2 module indicating an invalid EPC value has been
specified for an operation. This fault can occur if the read, write, lock, or kill command
fails.
Solution
Check the EPC value that is being passed in the command resulting in this error.
FAULT_PROTOCOL_INVALID_NUM_DATA – 411h
Cause
This error is used by the M5e GEN2 module indicating invalid data has been specified for
an operation. This fault can occur if the read, write, lock, or kill command fails.