ThingMagic M5e-Compact - Manual (Page 106)

Application Tag Commands
106 Command Set
Examples
The following example shows an attempt to kill a tag whose EPC
ID=0x112233445566778899AA and whose Kill password=0x11112222:
Note
If the tag’s kill password is set to 0, the protocol does not allow the tag to be
killed. A non-zero kill password must be set (using the
Write Tag Data
command) before the kill command succeeds. The RFU field should be set
to 0.
Error Status Codes
FAULT_MSG_WRONG_NUMBER_OF_DATA – 100h
FAULT_MSG_INVALID_PARAMETER_VALUE - 105h
FAULT_NO_PROTOCOL_DEFINED – 401h
FAULT_AFE_NOT_ON – 405h
FAULT_NO_TAGS_FOUND – 400h
FAULT_PROTOCOL_INVALID_ADDRESS – 409h
FAULT_PROTOCOL_INVALID_KILL_PASSWORD – 40Ch
FAULT_PROTOCOL_KILL_FAILED - 40Eh
FAULT_GEN2 PROTOCOL_OTHER_ERROR - 420h
FAULT_ANTENNA_NOT_CONNECTED – 503h
FAULT_TEMPERATURE_EXCEED_LIMITS – 504h
FAULT_HIGH_RETURN_LOSS – 505h
FF 13 26 03 E8 01 11 11 22 22 00 50
11 22 33 44 55 66 77
88 99 AA
DD DB
SOH Length OpCode Timeout (ms) Option Kill Password RFU Select
Data
Length
Select EPC ID CRC