Rice Lake iQUBE2 Digital Diagnostic Junction Box - Manual (Page 50)

46 iQUBE 2 Installation Manual
See Section 6.0 on page 46 for more information about the commands listed in Table 5-11.
Command
n = digital I/O bit number Description Values
DIGIOn Set digital I/O bit function OFF, ZERO, TARE, NT/GRS, UNITS, PRINT, CLRCN,
CLRTAR, SETPNT, CELHLTH, HOSTCTL
DIGIOn.SCALE Assign digital I/O bit n to scale 1–5 (scale number)
DIN#0 Read all digital inputs Returns value 0–F (status of bits 1–4 represented as
hexadecimal values 1, 2, 4, 8)
DIN#n Read digital input n 1=low, 0=high
DON#0 Set all digital outputs on (active) —
DON#n Set digital output n on 1–4
DOFF#0 Set all digital outputs off (inactive) —
DOFF#n Set digital output n off 1–4
MSDOUT Reads all outputs in the system —
Table 5-10. iQUBE 2 Digital I/O Commands
Command
s = scale number Description Values
DIA.PS Query power supply error —
DIA.MSCONNECT Query secondary connection error —
DIA.PSEXC Query excitation error —
DIA.CELLCONNECT Query cell connection error —
DIA.FLAGS Show all diagnostic flags simultaneously See Section 6.2.4 on page 50
DIA.CLEAR Clear all diagnostic flags —
DIA.OVERLOAD Query cell overload error —
SCs.DIA.OVERLOAD Set cell overload value –100.00 – 100.00 (percent)
DIA.UNDERLOAD Query cell underload error —
SCs.DIA.UNDERLOAD Set cell underload value –100.00 – 100.00 (percent)
DIA.ZREF Query zero reference error
SCs.DIA.ZREF Enable zero reference diagnostic OFF, ON
SCs.DIA.ZREF.RANGE Set zero reference range 0.00 – 100.00 (percent)
SCs.DIA.ZREF.THRESH Set zero reference threshold –100.00 – 100.00 (percent)
SCs.DIA.ZREF.TIME Set zero reference timer 1 – 60 (seconds)
DIA.DRIFT Query cell drift error —
SCs.DIA.DRIFT Enable cell drift diagnostic OFF, ON
SCs.DIA.DRIFT.RANGE Set cell drift range 0.00 – 100.00 (percent)
SCs.DIA.DRIFT.THRESH Set cell drift threshold 0.00 – 100.00 (percent)
SCs.DIA.DRIFT.TIME Set cell drift timer 1 – 300 (seconds)
DIA.SDALL Returns real-time load cell noise (in counts)
DIA.NOISE Enable peak-to-peak noise diagnostic OFF, ON
DIA.NOISE.THRESH Set peak-to-peak noise threshold for all scales 0.01 – 1000 (microvolts)
DIA.NOISE.TIME Set peak-to-peak noise timer 1 – 300 (seconds)
DIA.UNBAL Query unbalanced load error —
SCs.DIA.UNBAL Enable unbalanced load diagnostic OFF, ON
SCs.DIA.UNBAL.RANGE Set unbalanced load range 5 – 75 (percent)
SCs.DIA.UNBAL.THRESH Set unbalanced load threshold 0 – 50 (percent)
Table 5-11. iQUBE 2 Diagnostic Commands