Rice Lake iQUBE2 Digital Diagnostic Junction Box - Manual (Page 46)

42 iQUBE 2 Installation Manual
RESETCONFIGURATION Reset system, restore to factory defaults —
RESETDEFAULTS Reset system defaults but retain M/S
communications configuration (IDs and
addresses) —
SYSMODE Show current SW1 setup switch position Returns SETUP if SW1 is in CFG position;
WEIGH if SW1 is in OFF position
VOLTSEXC Show primary board excitation voltage —
VOLTSPS Show primary board power supply voltage —
WHOAMI Returns information about the iQUBE 2 including
master ID, version, and port configuration.
—
* These commands also store the configuration to EEPROM.
Command
s = scale number Description Values
SX Start streaming for all scales —
EX End streaming for all scales —
SCs.SX Start streaming for scale s —
SCs.EX End streaming scale s —
P Write one frame of polling format from all scales —
S Write one frame of streamed format from all scales —
SCs.COUNTS Read A/D counts —
SCs.CMV Read corrected mV value —
SCs.SIM Emulate cell NONE, 1–16
SCs.WEIGHT Read weight value —
SCs.ZERO Perform zero operation for scale s —
SCs.P Write one frame of polling format from scale s —
SCs.S Write one frame of streamed format from scale s —
SCs.TARE Perform pushbutton tare operation for scale s —
SCs.SETTARE Perform keyed tare operation for scale s —
SCs.PRINT Perform print operation for scale s —
SCs.CLRTARE Perform clear tare operation scale s —
SCs.GROSSNET Toggle gross/net mode for scale s —
SCs.GROSS Set scale s to gross mode —
SCs.NET Set scale s to net mode —
SCs.PRI Set scale s to primary units —
SCs.SEC Set scale s to secondary units —
SCs.UNITS Toggle primary/secondary units for scale s —
SCs.ZERO Perform zero operation for scale s —
Table 5-3. iQUBE 2 Weigh Mode Commands
Command Description Values
Table 5-2. iQUBE 2 System Commands (Continued)