Rice Lake iQUBE2 Digital Diagnostic Junction Box - Manual (Page 25)

Configuration 21
When configuration is complete, press the Save and Exit softkey to exit setup mode, then replace the setup switch
access screw.
Save and Exit writes all parameter changes to flash memory before returning to weigh mode in both iQUBE 2
and 920i .
After parameters changes are complete, it is necessary to download the configuration. See “Setting COMM Parameters and
Downloading Configuration” on page 25.
3.1.1 Connecting with the 920i
1. From the SERIAL menu, navigate to the PORTTYPE submenu and select the correct port type (see Figure 3-3).
2. Navigate to the CONFIG menu and press the Connect softkey.
3.1.2 Manual Assignment with the 920i
1. Navigate through the Serial menu as shown in Figure 3-3.
Figure 3-3. Boards Menu Selection
2. With the Boards menu highlighted, press the AUTOASSIGN softkey and then follow the “Push-Button Address
Assignment” on page 12 steps 1-3 to assign board addresses, or press the MANUAL ASSIGN softkey to show
the edit screen to manually assign the board addresses.
Figure 3-4. Edit Screen
Note
SCALES SERIAL FEATURE PFORMT SETPTS DIG I/O ALGOUT VERS
PORT 4
CONFIG
IQUBE2
BOARDS
1 4 2 3
Primary Board ID