Rice Lake iQUBE2 Digital Diagnostic Junction Box - Manual (Page 27)

Configuration 23
SERIAL Menu (PORTn, iQUBE Submenu)
Parameter Choices Description
Level 3 Submenus
COMM SEL IQ COM1
IQOPTCOM Selects whether to use the standard communications port (IQCOM1) or an option card
(IQOPTCOM) to communicate with the
920i .
PORTTYPE 232
422
485 Specifies whether the selected port is used for RS-232, RS-422, or RS-485
communication.
UPDATE 30HZ
50HZ
60HZ
100HZ
2.5HZ
5HZ
10HZ
15HZ
25HZ Update rate. Selects measurement rate, in samples per second, in which the 920i will poll.
Level 4 Submenus
SMPRAT 30HZ
50HZ
60HZ
100HZ
500HZ
2.5HZ
5HZ
10HZ
15HZ
25HZ Sample rate. Selects measurement rate of the analog-to-digital converter, in samples per
second. Lower sample rates provide greater signal noise immunity.
WARMUP 6
1-10 This sets a delay that causes the iQube 2 to not respond during warm up for a set amount
of time (in minutes).
DIGIO BIT 1 - BIT 4 Specifies the function of each of the digital I/O bits.
See the Level 5 Submenus for information about digital I/O functions.
COMM IQCOM1
IQOPTCOM Contains parameters for the communications option specified within the COMM SEL
parameter. See parameter descriptions under Level 5 Submenus.
BOARDS 1
2
3
4 Specifies how many CPU boards are connected to the iQUBE .
CELLS A1-4
B1-4
C1-4
D1-4 Contains parameters for setting the capacity, sensitivity, and ID number of each cell. The
number of cells depends on the number of boards selected in the BOARDS parameter (4
cells per board, 16 cells maximum). See parameter descriptions under Level 5 Submenus.
(Board 1=A, Board 2=B, Board 3=C, Board 4=D)
SCALES Enters the Scale Setup screen (see Figure 3-6 on page 25) where available load cells can be
associated with the scale.
Table 3-1. Serial M enu, PORTn, iQUBE Submenu Parameters