Rice Lake 320IS Plus Intrinsically Safe Digital Weight Indicator - Installation Manual - Manual (Page 46)

40 320IS Plus Installation Manual
3.2.9 Version Menu
The VERS menu is used to check the software or hardware version installed in the indicator. There are no
parameters associated with the Version menu; when selected, the indicator displays the installed software or
hardware version number.
Figure 3-14. Version Menu
TWZERO 65300
number Tweak zero. Adjust the analog output zero calibration. Use a multimeter to monitor the analog
output value. Press and hold
or to adjust the output. Press to save the new value.
Default value becomes 11000 if OFFSET is set to 20%.
TWSPAN 65300
number Tweak span. Adjust the analog output span calibration. Use a multimeter to monitor the analog
output value. Press and hold
or to adjust the output. Press to save the new value.
Default value becomes 54900 if OFFSET is set to 20%.
ALG OUT Menu
Parameter Choices Description
Table 3-9. Analog Output Menu Parameters (Continued)
Note
Note
SOFTWR
Software Version I/O Module Version
XXXXXXX XXXXXXX XXXXXXX XXXXXXX VERS ALGOUT DIG IN PROGRM PFORMT SERIAL CALIBR CONFIG FORMAT XXXXXXX SETPNT
I/OMOD
Displays “No Ver”
if no I/O Module is
connected