Dynojet 250i: Pit Installation Guide - Manual (Page 68)

In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Final Adjustments and Tests
2-46
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
FINAL ADJUSTMENTS AND TESTS
After you have installed all of your additional accessories and routed all necessary
cables, perform the following procedures to ensure the safe and effective operation of
your dyno.
Note: Before you plug in your dyno, you or your electrician must refer to
Appendix B for detailed power information.
Always turn the power off when connecting and disconnecting cables.
T URNING O N THE D YNO P OWER
1 Replace the CPI cover if it was removed. Refer to page 2-31 for more information.
2 Plug the power plug into the power outlet.
3 Turn on the main breaker inside the CPI door.
Note: Use the main breaker to turn power on and off to the dyno.
Figure 2-40: Turn on the Dyno Power
PD025
main breaker
power plug