Dynojet 250i: Pit Installation Guide User Manual
Page 36

In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Eddy Current Brake
2-14
3
Remove the eight bolts, washers, and six nuts from the dyno frame where the
connector plates will attach (where the connector plate attaches to the starter
brace, there are only two nuts). Refer to Figure 2-9.
4
Remove the starter brace and set aside. Only remove the starter brace when
installing the eddy current brake on the left (starter) side of the dyno.
5
Keeping the panels parallel, slide the eddy current brake towards the dyno. Slide
the coupler over the key on the dyno shaft. You will need to support the coupler
as you slide it onto the dyno shaft.
6
Continue sliding the eddy current brake towards the dyno until the uprights on
the brake and dyno are flush.
7
Loosely secure the connector plates to the dyno frame using the eight bolts,
washers, and six nuts removed earlier.
Note: Do not tighten the bolts.
8
Verify the uprights on the drum and eddy current brake modules are flush with
the top of the pit floor before you tighten the connector plates.
8a
Loosen all upright bolts.
8b
Place two straight edges across the drum module uprights as shown.
8c
With the upright tight against the straight edges, tighten the connector plate
bolts and nuts on the drum module.
Note: You can use c-clamps to attach the upright to the straight edges to make
this quicker. Tighten the c-clamps until the uprights are flush with the pit floor.
8d
Tighten the upright bolts and nuts on the drum module.
8e
Repeat this for the eddy current brake module uprights.
9
Secure the starter brace to the starter using the washer and nut removed earlier.
10 Remove the straight edges.
Figure 2-9: Secure the Uprights
PD183
front of
dyno
straight edge
c-clamp
starter brace
drum module
upright
eddy current brake
module upright
loosen bolts
securing
uprights
loosen bolts
securing uprights
(not visible)
loosen bolts
securing uprights
(not visible)
loosen bolts
securing
uprights
loosen bolts
securing
uprights
connector
plate bolts
connector plate bolts