Dynojet 250i: Pit Installation Guide - Manual (Page 56)

In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Routing Cables
2-34
7 Tighten the cable tie.
8 If you purchased the optional air brake, install the Emergency Stop Sticker at this
time. Refer to page 3-5 for directions.
9 Secure the rear cover to the control panel.
9a
Replace the four screws on the back of the cover removed earlier.
9b Replace the screw on the top of the cover removed earlier.
9c Replace the screw on the side of the cover removed earlier.
9d Replace the two nuts removed from the top of the cover removed earlier.
Figure 2-29: Replace the Control Panel Rear Cover
10 Secure the control panel to either side of the monitor tray using two 8-32-inch
screws.
Note: If you did not order a monitor tray, you will need to install the control pod
spindle on the bottom of your control panel using four 8-32 screws as shown in
the detail in Figure 2-30. Once installed, place the pin on the control panel into
the support arm where the monitor tray is.
11 Place the pendant in the slot on the control panel.
Note: If you plan on routing your cables through a zip tube refer to “Zip Tube” on
page 2-56 and skip the following steps.
12 Route the cable bundle along the support arms with service loops to allow
movement as shown below.
CP031