Dynojet 250i: Pit Installation Guide - Manual (Page 55)

I N S T A L L A T I O N
Routing Cables
Version 4 In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
2-33
4 Remove the control panel rear cover.
4a
Remove the two nuts from the top of the cover and set aside.
4b Remove the screw on the top of the cover and set aside.
4c Remove the screw on the side of the cover and set aside.
4d Remove the four screws on the back of the cover and set aside.
4e Remove the control panel rear cover and set aside.
Figure 2-27: Remove the Control Panel Rear Cover
5 Route the control panel cable through the access hole on the side of the control
panel box and through the cable tie.
6 Attach the control panel cable to the Button board.
Figure 2-28: Attach the Control Panel Cable to the Button Board
CP029
CP030
control panel cable with
cable harness wrap
access hole
cable tie
button board