Dynojet 250i: Pit Installation Guide - Manual (Page 60)

In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Routing Cables
2-38
R OUTING THE E DDY C URRENT B RAKE , B ATTERY , AND D YNO P OWER C ABLES
1 Route the eddy current brake cable (P/N 66952005) from the eddy current brake
through the designated power pit conduit and to the theta controller.
2 Route the battery cable (P/N 76950312) from the CPI through the same conduit
and over to the battery. Refer to the steps and Figure 2-34 on page 2-39 for
instructions on connecting the battery and starter cables.
Note: Be sure to keep the power and communications cables in different pit
conduits.
3 Route the temperature sensor cable from the eddy current brake through the
designated pit conduit and to the break-out board, see Figure 2-37.
4 Route the dyno power cable from the CPI to your power source, but do not plug
it in at this time.
Figure 2-33: Route the Eddy Current Brake, Battery, and Power Cables
PD169
battery cable
dyno power cable
CPI
eddy current
brake cable
battery
dyno
electronics
route power cables
in designated conduit
starter
starter cable
theta
controller
temperature
sensor cable