Dell PowerVault TL1000 - Manual (Page 80)

Configuring network settings
Select Configuration > Configure Network Settings to set the network settings for
the library.
Note: The Internet Protocol (IPv4, IPv6, or dual IPv4/IPv6) selection is used for
the TL1000 Tape Autoloader IP address, subnet mask, gateway address, time
server address, mail server address, SNMP trap address, and EKM server
addresses.
Configure the network with the following settings:
v Link Speed - Ethernet duplex mode (Auto, 10Base-T Full, 10Base-T Half,
100Base-TX Full, 100Base-TX Half).
v DHCP - (Dynamic Host Configuration Protocol) Enable DHCP to have the
library server or router negotiate the connection with the library.
– IPv4 - Select to enable DHCP with the IPv4 protocol.
– IPv6 - Select to enable DHCP with the IPv6 protocol
v IP Address - If DHCP is disabled, set the IP address of the library manually.
Configuration
Configure Network Settings
Configure Link Speed
Set Auto Negotiation
Set 10 Base-T Full
Set 10 Base-T Half
Set 100 Base-T Full
Set 100 Base-T Half
Configure DHCP
Configure DHCP IPv4
Enable DHCP IPv4
Disable DHCP IPv4
Configure DHCP Ipv6
Enable DHCP IPv6
Disable DHCP Ipv6
Set IP Address Ipv4
Change IP Address
Set IP Address Ipv6
Input IP Address
Input IP Address x 4
Change Subnet Mask
Set Subnet Mask
Set Prefix Length
Input Subnet Mask
Input Prefix
Change Gateway
Set Gateway Address Ipv4
Set Gateway Address Ipv6
Input Gateway
Input Gateway x 4
Figure 4-21. Network settings
4-12 Dell PowerVault TL1000 Tape Autoloader User's Guide
|