Dell PowerVault TL1000 - Manual (Page 39)

Chapter 3. Installation and configuration
“Choosing a location”
“Installing in a rack” on page 3-2
“Removing the accessor locking screw” on page 3-7
“Attaching the library to a server” on page 3-8
“Configuring your library with the
Web User Interface” on page 3-11 “Logging in to the Web User Interface” on page 3-12
“Checking firmware level” on page 3-13
“Configuring library settings” on page 3-14
“Configuring network settings” on page 3-16
“Configuring date and time settings” on page 3-17
“Configuring encryption settings” on page 3-18
“Configuring email notifications” on page 3-20
“Configuring trap notifications” on page 3-21
“Managing user access” on page 3-23
“Saving the library configuration” on page 3-24
“Configuring your library with the
Operator Panel” on page 3-24 “Logging in to the Operator Panel” on page 3-24
“Configuring network settings” on page 3-24
“Configuring library settings” on page 3-26
“Populating the library with cartridges” on page 3-27
“Verifying library and drive operation” on page 3-28
“Taking the Library Online” on page 3-29
“Registering for support notification” on page 3-29
To install and configure a TL1000 Tape Autoloader, complete these procedures in
the order they are presented.
Choosing a location
Table 3-1. Location criteria
Criteria Definition
Room temperature 16 - 32 °C (60 - 90 °F)
Voltage 100 - 240 Vac. (4.0 to 1.5 A)
Note:
The power switch is on the rear of the
library and must be easily accessible.
Frequency 50 - 60 Hz
Relative humidity 20 - 80% non-condensing
Air quality The library must be placed in an area with
minimal sources of particulate
contamination. Avoid areas near frequently
used doors and walkways, stacks of supplies
that collect dust, printers, and smoke-filled
rooms. Excessive dust and debris can
damage cartridges and the tape drive.
3-1
|
|