Dell PowerVault TL1000 - Manual (Page 76)

Select Commands > Move to Ship Position when the library is prepared to move
to a new location. The accessor must be placed in a parked position within the
library housing. Move to Ship Position finishes all active commands that are
received from the host application, does not process any new commands, and
moves the accessor to the parked position before the power is turned OFF.
1.
When Unlock Magazine is displayed, press the Enter key to unlock the
cartridge magazine. The magazine unlocks and the display prompts the
removal of the magazine.
2. Remove all cartridges from the magazine and reinsert the magazine into the
slide mechanism. The library completes an inventory to verify no cartridges are
in the magazine.
3. If the magazine is empty, the library moves the accessor to the ship position.
The library can be powered down. If the magazine is NOT empty, the library
prompts to remove cartridges. After all cartridges are removed and the
magazine is replaced, start the ship position process again.
Rebooting the drive
Select Commands > Reboot Drive to force the drive to reboot. You also specify
whether the library will come online or offline after it finishes rebooting.
Press the Enter key to reboot the drive.
Rebooting the library
Select Commands > Reboot Library to force the library to reboot. You also specify
whether the library will come online or offline after it finishes rebooting.
Press the Enter key to reboot the library.
Logging out of the library
Select Logout to log out of the library. The login screen is displayed for the next
user.
Commands
Reboot Drive
Figure 4-14. Reboot Drive command
Commands
Reboot Library
Figure 4-15. Reboot Library command
Logout
Figure 4-16. Logout command
4-8 Dell PowerVault TL1000 Tape Autoloader User's Guide